© 2013–2017 Schneider Electric All Rights Reserved
80043-808-02 Rev. 02 I-Line™ Combo Switchboards
03/2017 Installation—Interior Mounting into Square D Brand Enclosures
9
ENGLISH
3. Remove the interior trim from the trim brackets.
4. Install the interior as described below.
a. Set the interior on the enclosure studs and secure with flange nuts
(see Figure 1, Interior Mounting into Square D Brand Enclosures,
on page 10). Screwdriver blade may be inserted in elevating nut
slot to facilitate adjustment.
b. Adjust each elevating nut to maintain a maximum distance of
0.125 in. (3 mm) between the interior trim and the box bracket.
c. Tighten the flange nuts against the pan.
d. Install protective bolt head cap on each enclosure stud.
e. Remount the interior trim after wiring.
5. If used as service entrance equipment, neutral bonding is required
(see I-Line Combo Circuit Breaker Installation and Removal,
on page 10).
6. Apply equipment labels (located in the bag assembly) as directed by
the instructions on the back of the equipment label sheet.
Flush Mounting (Enclosure Recessed in Wall)
1. Mount the enclosure as instructed in the NEMA PB 1.1
standards publication.
2. Install one elevating nut on each enclosure stud.
3. Remove the interior trim from the trim brackets.
4. Install the interior as described below.
a. Set the interior on the enclosure studs and secure with flange nuts
(see Figure 1, on page 10). Screwdriver blade may be inserted in
elevating nut slot to facilitate adjustment.
b. Adjust each elevating nut to position the lip of the interior trim
approximately 0.25 in. (6 mm) from the outside wall line.
c. Tighten the flange nuts against the pan.
d. Install protective bolt head cap on each enclosure stud.
e. Remount the interior trim after wiring.
5. If used as service entrance equipment, neutral bonding is required
(see the I-Line Combo Circuit Breaker Installation and Removal,
on page 10).
6. Apply equipment labels (located in the bag assembly) as directed by
the instructions on the back of the equipment label sheet.
80043-808-01.book Page 9 Wednesday, March 22, 2017 12:31 PM