Thank you for purchasing the Square Jellysh Jelly Long Legs tripod. This
product is designed to be used with the Square Jellysh Spring Tripod Mount
for Tablets (sold separately). When used together, the tripod and spring
mount can support 7” tablets in both the vertical and horizontal positions.
The tripod may also be used alone for pocket cameras with standard screw
mounts. When not in use, the tripod legs fold up for added portability.
It couldn’t be easier
To use your Jelly Long Legs tripod, simply
attach the folded tripod to any device that
accepts a ¼ x 20 standard camera thread
screw. Once attached, unfold the legs to
their full position. Conrm that the set-
screw is tightened and place your camera
and Jelly Long Legs on a level surface of
your choosing. The rubber-tipped legs
help hold your tripod securely in place.
Alternatively, the legs of the tripod may
be individually adjusted in a range of angles. Using a screwdriver, slightly loosen
the set-screw and adjust each leg as desired. Then re-tighten the set-screw
and place your camera and Jelly Long Legs on a level surface. Check to make
certain your camera is well balanced; if not, adjust the legs as necessary.
Use common sense
• The Jelly Long Legs tripod is designed to hold the camera steady while taking
a picture. It is not designed to be mounted to a moving object or vehicle.
• Do not place your camera and Jelly Long Legs tripod where they can easily
fall a distance that would cause damage to your camera. A small railing and the
edge of a cliff are just a few examples that come to mind.
• This product contains small parts that may be a choking hazard. Keep out of
reach of children.
www.squarejellysh.com
Designed in USA. Made in China. Patents pending.
JELLY LONG LEGS TRIPOD USER’S MANUAL
Jelly Long Legs shown
with Spring Tripod
Mount for Tablets
Set-screw
To Next Page
Need help?
General
