To Next PageTo Next Page
Need help?Do you have a question about the Squire Stronghold and is the answer not in the manual?
Decide where to position the Stronghold® Keysafe, allowing space for the drawer to open.
Use the spacer as a template for drilling fixing holes in the wall as indicated.
Position the spacer on the wall with "TOP" uppermost and use screws in the upper holes.
With the dials at 00000, pull the knob to allow the drawer to slide out.
Remove knob retention screw, store safely, and push the spindle towards the Keysafe.
Remove the weatherproof cover and side screws to remove the drawer.
Position Keysafe over wall screws and slide down to align additional fixing holes.
Use security screws and Torx wrench to affix the Keysafe securely to the wall.
Position the drawer in open position and reattach retaining screws.
Hold the weatherproof cover in situ and push it firmly over the Keysafe.
Reattach the Pull knob with its retaining screw.
Test operation by setting code to 00000, opening and closing the drawer.
Scramble wheels to lock drawer, then reset to 00000 to test opening.
Affix the small rubber moulding to the end of the Pull knob to cover the screw head.
General