Reduce the canopy in preparation for d-bag placement.
5 6
1 2
We recommend PRO (Proper Ram-air
Orientation) packing your OMICRON. For
wingsuit deployments, it is not necessary to
roll the nose or dress it in any special manner.
Consistent with normal PRO packing technique
bring lines to the center of the pack job with folds
neat and symmetrical.
Lay the pack job down on the ground as per
standard PRO packing technique. Thanks to the
ultra-light material, this part will be much easier
than you’re used to! Remember to leave some
open space where the tail wraps around the line
group. Do not tightly wrap the tail at this section!
Bring the trailing edge (tail) around the pack job.
For wingsuit deployments, do not roll the tail
tightly around the pack job. One or two simple
folds, well below the line group, is adequate.
Please note that the trailing edge is only folded
slightly at the lower (the packer’s right) hand. At the
line group, there is plenty of “open” tail.
Reduce the pack job volume in preparation for
d-bag placement. For wingsuit deployments,
remember to leave the tail section open enough
to allow airflow in during extraction.
3 4
Do not roll
tightly here
7
Packing Your OMICRON
To Next Page
Loading...
Need help?
General
