EasyManua.ls Logo

SR Research EyeLink Portable Duo Quick Start Guide

SR Research EyeLink Portable Duo
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
EyeLink Portable Duo Quick Start Guide
5
1
Basic PC Setup
With the Laptop Host PC (included) powered off, connect its power supply. Set up the basic
components of the Display PC as you would any other computer. The Display PC can be any
modern 15” or 17” laptop computer running on Windows (XP, Vista, 7, or 10), Mac OS X
(10.6.8 or later), or Linux PC with an Ethernet port. This computer may have been oponally
acquired from SR Research.
Laptop Host PC with Laptop Mount
Test that the Setup is Working
Turn on the Host PC to verify that the Host
Applicaon starts. Once the Host PC is up and
running you should see the Camera Setup
screen.
To exit to the File Manager from the Host Applicaon, press Ctrl-Alt-Q (or click the “Exit
buon on the Setup screen and then select “Exit”). The File Manager interface is illustrated
below. You can use the buons highlighted below to start the Host PC Applicaon or shut
down the Host PC.
Starts Host Applicaon
Shuts down Host PC
Connued
on back
4
2
3
Display PC
See Chapter 6 of the EyeLink Portable Duo Installaon Guide for detailed instrucons
Host PC to Display PC Connecon
Using the Ethernet cable supplied, connect the Host PC
Ethernet port to an Ethernet port on your Display PC.
Configure that Display PC Ethernet port with the
following stac IP address:
IP Address: 100.1.1.2 Subnet Mask: 255.255.255.0
Surge Protector
Laptop Host PC
Display PC
2
3
Camera Connecon
Connect both plugs at the end of
the eye trackers cable into the USB
3.0 ports on the Host PC.
Adjust the span of the laptop mount with the
supplied tools to fit the intended Display laptop
PC. Place the camera upside down on a desk
with the screw holes facing up, then the laptop
mount on the camera, and install the two screws
through the mount and into the camera with the
supplied tools. Place the laptop mount on the
Display laptop PC with the two side rails resng
on the edges of the laptop.
R
Leave the default gateway and other sengs blank.
Aach the Laptop Mount to the Camera
Version 1.02L
See Chapter 4 of the EyeLink Portable Duo Installaon Guide for detailed instrucons
USB1000-880-WA
EyeLink USB Camera
Serial # CAA11
SR Research Ltd.
Made in Canada
5V @ 1.8A
IP21
82123730156
Install two camera screws with the supplied Allen Key

Other manuals for SR Research EyeLink Portable Duo

Question and Answer IconNeed help?

Do you have a question about the SR Research EyeLink Portable Duo and is the answer not in the manual?

SR Research EyeLink Portable Duo Specifications

General IconGeneral
TypeEye Tracker
Tracking TypeBinocular
Resolution0.01°
Accuracy0.25° - 0.5°
CompatibilityWindows
Calibration Type9-point, 5-point
Pupil Diameter Resolution0.1 mm

Related product manuals