CARE AND STORAGE
Only remove the QTS sleeve when making adjustments. All parts
should remain properly installed at all other times, including when
the club is in storage, to ensure that no foreign objects or debris
become lodged in the sleeve connection or screw holes.
If the QTS sleeve becomes soiled with water, dirt, or other debris,
wipe them clean with a cotton swab or a soft, clean cloth.
When removing the QTS sleeve, be sure that you do so in a
clean location to ensure that no foreign objects or debris
become lodged inside.
It may even cause internal damage to the club head, adversely
affecting club performance.
Do not heat the QTS sleeve as it may damage the product.
Please be aware that attempts to remove the QTS sleeve or intentionally
disassembling it may not comply with the manufacturer’s warranty.
*For information on manufacturer’s warranty regulations, please refer to
the owner’s manual and warranty included with your golf club.
Avoid adjusting the QTS sleeve when the temperature is below
-5°C or above 45°C, as it may damage the sleeve.
experience, please be sure to follow these Important Precautions.
The manufacturer assumes no liability for injury or product damage due to failure to comply with the instructions herein.
Rules of Golf
You may not change the QTS sleeve position during a round.
SRIXON Z Series clubs conform with R&A and USGA-approved Rules of Golf. However, it
is against the rules to modify club performance during a round by changing the QTS
sleeve position to change the CG position, as this breaches the Rules of Golf regulation
4-2a, which states: “During a stipulated round, the playing characteristics of a club must
not be purposely changed by adjustment or by any other means.”
Important
Precautions
To ensure a safe and satisfying golfing
Be sure to read the Important Precautions carefully and exercise appropriate care.
To Next Page
Loading...
