HOW TO INSTALL AND REMOVE QTS SLEEVE
(SLEEVE INSTALLATION)
Insert the shaft into the head QTS setting examples
The shaft may not insert fully if the position line
and sleeve mark are not correctly aligned.
Press the shaft all the way in until the QTS
sleeve is completely covered.
Align the position line with the
mark and press straight in.
* Illustration shows neutral position
For right position
(Open face)
For left position
(Closed face)
Align the mark on the head with the ‘R’
on the QTS sleeve and press straight in.
Align the mark on the head with the ‘L’
on the QTS sleeve and press straight in.
Check to see that the QTS sleeve is properly secured.
Tighten the sleeve until you hear a
‘click’. If you fail to properly secure
the sleeve, there is a possibility that
the head may come off in mid swing,
injuring either you or a bystander.
To Next Page
Loading...
