Need help?Do you have a question about the SRS Labs PTC10 and is the answer not in the manual?
Discusses the I/O card slots and installation process for the PTC10.
Guides the user through the initial setup and basic operation of the PTC10.
Explains how to select sensor types and calibration curves for accurate readings.
Explains how data is logged to the PTC10's internal RAM.
Details the process of logging data to USB memory devices.
Describes how to connect and interface the PTC10 with a computer.
Explains how to query data from the PTC10 via its communication interfaces.
Explains how to control temperature using PID feedback loops.
Describes how to enable and configure the lowpass filter for improved performance.
Details how to set up alarms for system protection and monitoring.
Explains how to set up the PID feedback loop parameters.
Introduces the relay tuner and step response tuner for automatic PID tuning.
Guides on how to use the automatic tuner to optimize PID parameters.
Explains the function of the front panel menu keys and buttons.
Introduces the "Program" screen for creating and running user programs.
Details how to send programs via communication interfaces.
Guides on entering programs directly from the PTC10's front panel.
Compares different PID tuning types and their responses.
Explains channel configuration settings including PID controls and alarms.
Covers alarm configuration for input channels, including limits, mode, and output actions.
Describes alarm trigger conditions and actions for input channels.
Details calibration settings for input channels, including type and coefficients.
Covers PID control configuration for output channels, including input, mode, and setpoint.
Shows how to display PID status and configure cascade control.
Details settings for the PID autotuner, including Step Y and Lag.
Covers global instrument settings like time, date, and logging.
Configures serial (RS-232) and USB communication settings.
Configures network settings for Ethernet communication.
Controls display settings such as brightness, units, and plot types.
Adjusts system-wide settings like fan speed, volume, and time/date.
Provides instructions for updating the PTC10's firmware.
Explains how to establish remote communication with the PTC10 via various interfaces.
Explains the syntax rules for remote commands and macros.
Covers alarm configuration for input channels, including limits, mode, and output actions.
Covers PID control configuration for output channels, including gain factors.
Enables and disables PID feedback, and sets control modes.
Details settings for the PID autotuner, including mode and type.
General| Brand | SRS Labs |
|---|---|
| Model | PTC10 |
| Category | Temperature Controller |
| Language | English |
To Next Page