Page 16
CLEANING INSTRUCTIONS
AFTER FERMENTATION HAS FINISHED, CLEAN AND DRAIN THE SYSTEM
1. Remove the FTSs
2
immersion coil from the drained fermenter.
2. Remove the tubes from the immersion coil and pump.
3. Remove the immersion coil and thermowell from the FTSs
2
lid.
4. Fully drain the remaining chilled water from the system.
5. Soak the stainless parts in PBW or similar caustic to remove any proteins that have adhered to the
surfaces.
6. Follow the cleaning instructions - products like PBW depend on concentration, temperature and
duration to do a proper job of cleaning.
7. Drain, rinse and allow every component of the system to air dry.
To Next Page
Loading...
Need help?
General