01-26
undefined
0000-00
ENGINE GENERAL
Plug the removed components with clean
and undamaged sealing caps and store it
into the box to keep the conditions when
it was installed.
Clear the high pressure offset value by
SCAN-100 after replacing the high
pressure pump.
7.
8.
To supply the fuel to transfer line of HP
pump press the priming pump until it
becomes hard.
9.
Do not crank engine before having
filled pump.
-
Check the installed components again
and connect the negative battery cable.
Start the engine and check the operating
status.
With SCAN-100, check if there are
current faults and erase the history faults.
10.
11.
Priming pump
To Next Page
Loading...
Need help?
General
