SSP PR-348 - Page 10

SSP Professional Lighng
www.sspworld.com
10
5) Exit Edit mode.
EXAMPLE: Insert a step with channels 1-12 fully on at a time between step 4 and 5 of program 35.
1) Record enable.
2) Push Channel sliders 1-12 to the top and record the scene as a step.
3) Tap the Mode Select button to select CHNS SCENE mode.
4) Tap the Page button until Page 2 LED lights.
5) Tap the Flash button 35 while holding down the Edit button, the corresponding scene LED
lights.
6) Tap the Step button to scroll to the step 4.
7) Tap the Insert button to insert the scene you’ve created before.
2.7 Modify a Step or Steps
1) Enter Edit mode.
2) Tap the Step button to scroll to the step you wish to modify.
3) Press and hold the Up button if you want to raise the intensity. If you want to lower the intensity,
press and hold down the Down button.
4) While holding down the Up or Down button, tap the Flash button corresponding to the DMX
channel of the scene you wish to modify until you reach the desired intensity value read from the
Segment Display. Then you may tap the Flash buttons until you are satised with the new scene.
5) Repeat steps 2, 3 and 4 until all the steps have been modied.
6) Exit Edit mode.
3. Running
3.1 Running Chase Programs
1) Tap the Mode Select button to select CHNS SCENES mode indicated by the red LED.
2) Tap the Page button to select the correct page the program you wish to run is located.
3) Push Master Slider B to its maximum position(fully down).
4) Move the desired Channel slider (25-48) to its maximum position to trigger the program, and the
program will fade in depending upon current fade time.
5) Move the Channel slider to adjust the output of the current program.
3.2 Running a Program To Audio
1) Use built-in microphone or plug the audio source into the RCA Audio jack.
2) Select your program as described above.
3) Tap the Audio button until its LED lights, indicating Audio mode is active.
4) Use the Audio level slider to adjust the music sensitivity.
5) To return to normal mode, tap the Audio button a second time causing its LED goes out, the

