11
Audio mode is disengaged.
3.3 Running a Programs With the Speed Slider
1) Be sure the Audio mode is disengaged, that is the Audio LED goes out.
2) Select your program as described above.
3) Move the Speed slider to the SHOW MODE position (the button), then tap the Flash button (25-
48) while pressing and holding down the Rec. Speed button, the corresponding program will not
run with the Standard beat any longer.
4) Now you may move the Speed Slider to select your desired speed.
NOTE:
The step 3 is not necessary if the selected program is not recorded with Standard Beat.
3.4 Running a Programs With the Standard Beat
1) Be sure the Audio mode is disengaged. Tap the Mode Select button to select CHASE SCENE
mode.
2) Tap the Park button to select Mix Chase mode, the LED lights indicating this selection.
3) Select your program as described above.
4) Move the Speed slider until Segment Display reads your desired value. You may tap the Tap
Sync button twice to dene your beat time.
5) While pressing and holding down the Rec. Speed button, tap the Flash button(25-48) that
stores the program.
6) The program will then run with the set time or beat when engaged.
7) Repeat steps 4 and 5 to set a new beat time.
4. Chang the Speed Mode between 5 Minutes and 10 Minutes
1) Press and hold the Record button.
2) Tap the Flash button 5 or 10 three times while holding down the Record button.
3) The 5 MIN or 10 MIN should light up indicating the Speed slider is set to run in the 5 or 10 min-
ute mode..
5. MIDI
5.1 Setting MIDI IN
1) Tap the Flash button 1 three times while holding down the Record button, the Segment Display
reads “CHI” indicating MIDI IN channel setup is available.
2) Tap the Flash button numbered from 1-16 to assign MIDI IN Channel 1-16
To Next Page
Loading...