002
Unpacking and Assembly
Quick Start Guide
Introduction
WWW.STUPIDSIMPLE.TOOLSSST003
1. Remove from Packaging
2. Install pressure gauge
a. Apply teflon tape to male thread to ensure a proper seal
3. Mount your MEGAFLOW
01
DO NOT USE MEGAFLOW IN SYSTEMS WITH THESE CHEMICALS.
Polycarbonate is a tough and transparent polymer, but is
susceptible to chemical damage from compressors lubricated
with synthetic oils, or oils containing phosphate esters or
chlorinated hydrocarbons. Exposure to these chemicals can
cause hazing, cracking, or explosions.
CHEMICAL COMPATIBILITY WARNING
BACK MOUNT USING M8 HOLES ON BACK FRONT MOUNT USING MOUNTING BRACKET
To Next Page
Loading...