SSV Works MRB3 - Page 9

S. Connect the factory USB port to the power ground . Reference the back of
the USB port to identify which terminal is power or ground .
U. Connect the MRB3 front speaker output to the RKR-2K input.
W. Connect the MRB3 power connector to the RKR - 2K power output.
T. Connect the antenna.
V. Align the arrows on the wire control panel with the arrow on the
MRB3 controller connector and connect.
X. Place the now connected MRB3 brain in its mounting position over
the holes drilled in Step L.
5