RZ4-F65
RZR XP1000 & 2014+ RZR900
6.5” Speaker Front Kick Panels
SSV WORKS, 201 N. Rice Ave Unit A, Oxnard, CA 93030
www.SSVworks.com | Phone: 818-991-1778 | Fax: 866-293-6751
!
Please read and understand these
instructions completely before
installation to avoid possible injury, or
damage to the accessory or vehicle.
WARRANTY INFORMATION:
All SSV Works enclosures are covered by a limited lifetime warranty against defects
in material or workmanship. All SSV Works Electronics are covered by a limited 1 year
warranty against defects in material or workmanship. All SSV Works Speakers are
covered by a limited 1 year warranty against defects in material or workmanship. Labor
for replacement of defective components is not covered. Contact SSV Works for further
warranty information.
TOOLS NEEDED FOR INSTALLATION
PARTS LIST IMAGES
2. #14 Screws x4
1. RZ4-F65 Enclosures
(1 pair)
3. #7 Screws x8
- T-40 Torx Driver - #2 Phillips Screwdriver
B. Place the driver kick pod into location so that both vehicle
screw bosses line up with kick pod brackets.
B
A. Starting at driver side footwell, remove the factory T40 torx
screw as shown.
A
To Next Page
Need help?
General
