ST7735R
V0.2 72 2009-08-05
9.15.2 Reset Table (GM[1:0]= “00”, 132RGB x 162)
Item After Power On After H/W Reset After S/W Reset
Frame memory Random No Change No Change
Sleep In/Out In In In
Display On/Off Off Off Off
Display mode (normal/partial) Normal Normal Normal
Display Inversion On/Off Off Off Off
Display Idle Mode On/Off Off Off Off
Column: Start Address (XS) 0000h 0000h 0000h
Column: End Address (XE) 0083h 0083h
0083h (131d) (when MV=0)
00A1h (161d) (when MV=1)
Row: Start Address (YS) 0000h 0000h 0000h
Row: End Address (YE) 00A1h 00A1h
00A1h (161d) (when MV=0)
0083h (131d) (when MV=1)
Gamma setting GC0 GC0 GC0
RGB for 4k and 65k Color Mode Random values Random values No Change
Partial: Start Address (PSL) 0000h 0000h 0000h
Partial: End Address (PEL) 00A1h 00A1h 00A1h
Tearing: On/Off Off Off Off
Tearing Effect Mode (*1) 0 (Mode1) 0 (Mode1) 0 (Mode1)
Memory Data Access Control (MY/MX/MV/ML/RGB) 0/0/0/0/0 0/0/0/0/0 No Change
Interface Pixel Color Format 6 (18-Bit/Pixel) 6 (18-Bit/Pixel) No Change
RDDPM 08h 08h 08h
RDDMADCTL 00h 00h No Change
RDDCOLMOD 6 (18-Bit/Pixel) 6 (18-Bit/Pixel) No Change
RDDIM 00h 00h 00h
RDDSM 00h 00h 00h
ID2 NV value NV value NV value
ID3 NV value NV value NV value
Note: TE Mode 1 means Tearing Effect Output Line consists of V-Blanking Information only
To Next Page
Loading...
