3
I
ncorrectly installed equipment may fail, causing severe injury
or property damage. Read and follow operational parameters given below
when installing equipment described in this owner’s manual.
1
. Follow instructions and procedures in owner’s manual for installation,
operation, and maintenance of equipment.
2. Do not connect any part of pool or spa system to city water system, well
water system, or to any other type of high pressure water system or supply.
3. Do not attempt to use pool or spa equipment in any type of installation
other than a pool or spa.
4. Trapped air under pressure in system can cause explosion and serious in-
jury. Follow instructions in owner’s manual or on equipment to make sure
that no air is trapped in the system before testing or operating equipment.
Equipment that is incorrectly pressure tested may explode,
causing severe injury or property damage. Pressure testing should only be
done by trained pool professionals, following test parameters given below
when testing the equipment described in this owner's manual.
1. Make physical check for correct tightness of all clamps, bolts, lids, and
system accessories prior to test. See owner’s manuals covering equipment
being tested for this information.
2. Make sure there is no air entrapped in system. Release all air in system
before testing.
3. When using a Sta-Rite pump and trap, tighten trap lid to 30 ft. lbs.
(4.1 kg-m.) torque before testing.
4. Water pressure for testing must be 25 PSI (172kPa) or less.
5. Water temperature for testing must be 100°F (38°C) or less.
6. Test length must be 24 hours or less.
7. After test, make visual check of system to make sure that it is ready for
operation. Remove Sta-Rite trap lid and retighten hand-tight only.
8. Exceeding any one of limits 2 through 6 or omitting physical checks
specified in Steps 1 and 7 can result in equipment and property damage
or physical injury.
NOTICE: These parameters apply to Sta-Rite pool and spa equipment only.
For non-Sta-Rite equipment, consult manufacturer.
If filter clamps are
adjusted or removed
under pressure,
tank may explode,
causing severe injury or
major property damage.
BEFORE WORKING
ON FILTER:
1. Stop pump.
2. Open air release
valve.
3. Release all pressure
from system.
Filter pumps require
hazardous voltage
which can shock,
burn, or cause death
BEFORE WORKING
ON PUMP OR MOTOR
Disconnect power to
motor.
To Next Page
Loading...