your level to reach level or plumb without looking at your level
module LCD.
o How to Use: Simply push the sound button to turn it on, or
push the same button to turn it off. It is that simple.
MODE= (contractor language)
o Explanation: This button controls which dimension (language)
your electronic module will measure (speak) in. Your level has
the capability to speak in Degrees, Percentage of slope,
Millimeters per Meter, Inches per foot (Slope, Pitch) in decimal
form and Inches per foot in fractions of an inch. A symbol on
the upper right hand corner of either screen will explain which
MODE you are currently in. Besides working in the language
that you use, this multi MODE function empowers you to switch
from one MODE to another to do conversions. (example: convert
inches per foot to degrees to make a cut)
o How to Use: Simply push the Button that is labeled MODE to
switch from one language to another. Which ever MODE you are
in when the level is powered off will be the MODE displayed
when the level is powered back on.
o Note: This unit has “higher resolution” than the previous model.
Definition: is two digits after the decimal in degree mode. You can
have this on or off by simply pressing the mode button.
REF= Reference
o Explanation: The Reference function in this level is designed to
make it quicker and more consistent when doing the same angle
or slope continuously. You are able to make any angle or slope
To Next Page
Loading...
Need help?
General
