Stack-On GCM-1918-DXTX

To Next Page

FOAM PAD FOR BOTTOM

(QUANTITY 1)

Rev2207

Record the key number and serial number from the back of the cabinet.

Keep keys in a secure place away from children.

Do not store this document in the cabinet

Instructions

GCM-1918-DXD

GCM-1918-DXF

GCM-1918-DXTX

PARTS INCLUDED

Serial #:

Key #:

WARNING

Tip Over Hazard

A child or adult can tip the cabinet and be killed or

seriously injured.

Failure to secure the cabinet as shown in these

instructions can result in death or serious injury to

children and adults.

Children should not play with or around the

cabinet at any time.

IMPORTANT:

Tools Required:

Phillips screwdriver

7/16” wrench

drill

3/16” drill bit

Scissors

Hardware included:

(22) 8-32 x 1/2 machine screw

(22) 8-32 nut

(12) 8 x 1/2 screw

PLASTIC PLUG

(QUANTITY 2)

SCOPE REST

(QUANTITY 4)

5-POSITION BARREL REST

(QUANTITY 2)

4-POSITION BARREL REST

(QUANTITY 2)

WARNING: This product can expose you to chemicals

including Di(2-ethylhexyl)phthalate (DEHP) which is known

to the State of California to cause cancer and birth defects

or other reproductive harm. For more information go to

www.P65Warnings.ca.gov

For warranty and customer support, please register this

product at “www.Stack-On.com/product-registration”

THE BARREL RESTS MUST BE INSTALLED BEFORE

MOUNTING THE CABINET TO A WALL AND FLOOR.

Installation of Barrel Rests

Install the 4-position barrel rests (A) to the back of the cabinet and the

Align the holes of the barrel rest over the tips of the screws and lightly

press the barrel rest into place. Now tighten the screws from the

outside of the cabinet. Tighten each screw partially, alternating from

one screw to the other until they are both tight. Do not over tighten.

INSTALLATION OF BARREL RESTS

Main Page

Need help?

Do you have a question about the Stack-On GCM-1918-DXTX and is the answer not in the manual?

Summary

INSTALLATION OF BARREL RESTS

Installation of Barrel Rests

Install the 4-position barrel rests (A) to the back and 5-position barrel rests (B) to the sides of the cabinet.

INSTALLATION OF SHELF

Top Shelf Assembly

Assemble the top shelf to the center partition and sides of the cabinet using nuts and bolts.

SECURING THE CABINET

Securing the Cabinet

Mount the cabinet to wall studs and the floor for safety and security. Consult hardware retailer for fasteners.

Selecting a Location

Choose a location adjacent to a wall, ensuring the cabinet is flat against the wall and floor.

FOAM INSTALLATION

Foam Installation

Place the foam onto the bottom of the cabinet, cutting it to fit around the center partition if used.

INSTALLATION OF SCOPE STAND-OFF

Installation of Scope Stand-Off

Screw the scope stand-off into the pilot hole of the barrel rest as needed for gun storage.

LIMITED ONE YEAR WARRANTY

Limited One Year Warranty

Details the warranty coverage for steel cabinets and pistol cases, excluding misuse or unauthorized repairs.