STACYC 18EDRIVE - Page 24

P a g e | 24P a g e |
Cycle stopped
working while
riding
Short run me/
runs slow
Runs
intermiently
Cycle does not
stop when apply-
ing the brake
Cycle makes
squeaky noises or
grinding sounds
Motor or electrical system damage
Verify baery is installed unl baery
release buon “clicks”. Contact your local
authorized service center for diagnosis and
repair.
Recharge or Replace baery
Verify the baery is fully charged
Inate res to the recommended pressure
on re sidewall. Replace tube if unable to
maintain pressure.
Replace baery
Contact your local authorized
service center for diagnosis and repair.
Check for loose connecons/wires
Dry aected area and inspect for damage
Adjust brake
Apply a chain lubricant to the chain
Contact your local authorized
service center for diagnosis and repair
Refer to brake component manual
Contact your local authorized
service center for diagnosis and repair.
Watch for error codes on LED indicang
overload/overheat. Do not exceed the
weight limit of 115 lb (52 kg), ride on at
terrain.
Loose baery or wire connecon(s)
Power buon faulty
Throle faulty
Rider weight / Terrain too steep
Baery not fully charged
Old or damaged baery
Tire is not properly inated
Loose connecon(s)
Motor or electrical system damage
Water in electronics
Faulty power buon
Faulty throle
Brake is not adjusted properly
Chain is too dry
Brakes are not adjusted properly
For more troubleshoong ps, a list of available replacement parts, or to locate an authorized
Service Center in your area, visit our website at www.STACYC.com
PRODUCT PARTS:
Visit www.STACYC.com for informaon on spare part availability. (Illustraons may not reect
exact appearance of actual product, specicaons subject to change without noce.)
PROBLEM:
POSSIBLE CAUSE:
SOLUTION:
Power Buon
is turned “ON”,
cycle does not
work
Baery not installed or fully seated
Verify a fully charged baery is installed
unl baery release buon “clicks”
Verify the baery is fully charged
Baery not fully charged