STACYC 18EDRIVE - Repair & Maintenance

P a g e | 22P a g e |
Note: Chain may be greasy and dirty.
Turn power switch to “OFF” posion, remove baery, allow cycle to cool before beginning
repair or maintenance:
1. Ensure the power buon is “OFF”.
2. Ensure the baery is removed and cycle has had adequate me to cool. (up to 30 minutes)
3. Secure the cycle for repair or maintenance.
4. Exercise cauon around exposed parts.
5. Remove right side panel.
6. Rotate rear wheel unl master chain link is near motor sprocket.
7. Loosen both rear axle nuts, bolt securing brake bracket and loosen chain tensioner.
8. Push wheel forward to loosen chain.
9. Remove master chain link, then chain.
10. Install replacement chain, re-aach master link.
11. Tension chain by pulling rear wheel outward with aid of chain tensioner, aligning the re
straight forward.
12. Tighten rear axle nuts, bolt securing brake bracket and snug chain tensioner.
13. Install right side panel.
Replace Front Tire and/or Tube:
1. Loosen front axle nuts and axle keeper tabs.
2. Remove wheel.
3. Deate tube and remove re from wheel.
4. Install new re and/or tube onto sidewall.
5. Inate to pressure recommended on sidewall.
6. Install front wheel and ghten from axle nuts, posioning axle keeper tabs into lower hole
in fork blade.
Replace Rear Tire and/or Tube:
1. Remove right side panel.
2. Snip zip-e on hose keeper on the chain stay near side panel.
3. Remove brake caliper bracket bolt.
4. Remove disc guard.
5. Loosen rear axle nuts and remove chain tensioner assembly.
6. Push rear wheel forward and remove chain from motor sprocket.
7. Remove rear wheel.
8. Deate tube and remove re from wheel.
9. Install new re and/or tube onto wheel.
10. Inate to pressure recommended on sidewall.
11. Replace wheel assembly in dropouts and disc guard.
12. Tension chain by pulling rear wheel outward with aid of chain tensioner, aligning the re
straight forward.
13. Tighten rear axle nuts, bolt securing brake bracket and snug chain tensioner.
14. Install right side panel.
Seat Height Adjustment:
1. Release the seat height adjustment clamp and extend the seat post unl the desired seat
height is achieved, then ghten the adjustment clamp. The seat post is marked with
anindicator line. Do not extend past the indicator line.