!
Unpacking: Thank you for purchasing this product. Every model has been
thoroughly tested and has been shipped in perfect operating condition.
Carefully check the shipping carton for damage that may have occurred during
shipping. If the packaging appears to be damaged, carefully inspect your product
for any damage and be sure all equipment necessary to operate the unit has
arrived intact.
Introduction: This product has 4 and 7 DMX channels. It can operate in 4
different modes: automatic, DMX control, sound-active, or in a master/slave
configuration. This product comes with several built-in programs that can be
used, while operating as a dimmer unit or when used in multiples linked in a
master/slave configuration. For best results, use in conjunction with fog or
special effects machines to enhance the beam projections.
Warning! To prevent or reduce the risk of electrical shock or fire, do not expose
this unit to rain or moisture.
Warning! Avoid looking directly into the light source at all times! This may
cause severe eye damage.
Insta llation
1. The light can be installed anywhere, but the light must be at a distance of 1m
minimum from people or other objects at all times. Please make sure the light is
fixed steadily; moreover, the product should be earthed.
2. Please make sure the rated voltage and frequency suit your local voltage.
3. DMX512 connection：The DMX512 signal of the controller is connected
through the Input and Output 3pins XLR light sockets. (1 Earth, 2 Negative,
3 Positive)
The length of the signal cable should be less than 100m in order to avoid
interference. The light will work according to the IP Code which you selected
when you are using the DMX512 controller control equipment. Please refer to
the pictures below.
To Next Page
Loading...