Stagnoli E24 - Control Board Configuration Parameters; Setup, Read Code, and Adjustment Parameters; Function Parameters Overview

GB
23
function
adjustement
delete
Î
00 00
Í
• 00 00 = instant power absorbed by motor 1
and
motor 2.
delete
Ï
default parameter
language
Ï
italiano
setup
read code
erase 1 transmitter
erase memory transmitters
english
• setup = learning the stroke
•
read code= identification and reco-
gnition of transmitters
•
ttca = automatic closing time
• aped = pedestrian opening
• sfaa = delay in opening time of motor 2
• sfac = delay in closing time of motor 1
• rlap = slowed stroke in opening
• rlch = slowed stroke in closing
•
sbat = strike space
•
v rl = slowing speed
•
fm1a = anti-crushing force of motor 1 in opening
•
fm1c = anti-crushing force of motor 1 in closing
•
fm2a = anti-crushing force of motor 2 in opening
•
fmac = anti-crushing force of motor 2 in closing
•
tser = electric lock activation time
• fend = final thrust force on striking
• ca = automatic closing
• ba = blocks impulses during opening
• bp = blocks impulses during pause
•
cr = rapid closing
• 2p = open/close operation
•
pl = preflashing
• sv = suction lock
•
ar = impact on opening
• re = energy saving
•
1m = operation with one motor
• en = encoder operation
• ss = soft star t
• oc = open/close operation
•
it = total reversal after encountering an obstacle
• 2b = two safety ribs
•
cf = operation of the fixed code receiver
•
al = alarm
•
te = diagnostics check before every star t
• default parameter = setting of factory parameters
• erase 1 transmitter = cancels one transmitter
• erase memory transmitters = cancel all registered transmitters