To Next PageTo Next Page
Need help?Do you have a question about the Stagnoli H24 and is the answer not in the manual?
Introduces the H24 control board and its manual for professional use.
Covers safe installation, operational safety, gate checks, and end-user communication.
Visual representation of the control board with numbered components.
Detailed list of all numbered components on the control board.
Illustrates power connections, photocells, and other outputs with safety recommendations.
Explains wiring for NC/NO contacts, rib input, and earthing requirements.
Details initial wiring checks, gate movement, parameter learning, and safety device activation.
Explains setting anti-crushing force, performing test cycles, and measuring impact.
Explains how to access and move through the control board's menus using buttons.
Lists key function codes like 'r|=00', 'ttca', 'da', and their purpose.
Provides detailed explanations for various function codes like 'ttca', 'aped', 'fmla', 'da', etc.
Describes how to reset parameters, erase transmitters, and select the display language.
Guide to memorizing compatible radio controls and antenna considerations.
Details parameters like 'ttca', 'aped', 'rlap', 'rlch', 'fmla', and 'fmlc' for gate operation.
Explains functions like 'da' (opening direction), 'ca' (auto closing), 'cr' (rapid closing), and '2p' (open/close).
Details functions such as 'ba' (block opening), 'bp' (block pause), and 'pl' (preflashing).
Explains 're' (energy saving) and 'fcm' (magnetic limit stop).
Covers 'en' (encoder), 'SS' (soft start), 'OC' (open/close), 'it' (total reversal), and '2b' (two safety ribs).
Details 'cf' (fixed code receiver) and 'al' (alarm) functions.
Describes how to reset parameters, erase transmitters, and change display language.
Procedure for automatically setting gate start and end strokes and force parameters.
How to check memorized transmitter codes and view system statistics.
Explains various codes like 'rf', 'sta', 'ped', 'ph0', 'ERR', 'full' for system status.
Addresses FAQs regarding transmitters, batteries, and motor behavior.
Lists key technical data such as supply voltage, fuses, receiver capacity, and output power.
Visual guide showing where to connect various components like motor, safety, and commands.
Detailed wiring diagrams for opening and closing photocells.
Instructions for connecting batteries and the battery-charger board.
General| Brand | Stagnoli |
|---|---|
| Model | H24 |
| Category | Control Unit |
| Language | English |
