Stagnoli HERMES - Installation and Fixing Procedures; Preliminary Checks and Gear Motor Fixing

Istruzioni Instructions Instructions
- 14 -
Preliminary checks and fixing the gear motor
• Check that the gate structure is sufficiently sturdy and there are no points of friction.
• Make sure the gate hinges are working properly and adequately lubricated.
• Check there are mechanical stops in closing and opening.
• Prepare for fixing the gear motor to the gate as illustrated in figure.
Attention!
To ensure the smooth operation of the engine installation of units strictly observe the
following.
B \ A 80 100 120 140 160 180 200 220 240 260
100 90 100 110 115 120 105 100 95 90 90
120 90 100 110 110 110 100 95 90
140 100 105 105 100 95 90
160 95 100 100 90
180 95 95
200 95
B \ A 80 100 120 140 160 180 200 220 240 260
100 730 745 765 780 795 770 755 735 710 700
120 750 765 785 790 795 775 755 735
140 785 795 800 795 775 755
160 800 805 810 785
180 820 820
200 840
TABLE OF INSTALLATION QUOTE FOR HERMES WITHOUT MECHANICAL STOPS
OPENING ANGLE : C
POSITION FRONT BRACKET : D