EasyManua.ls Logo

Stahl 8485/111-42 - User Manual

Stahl 8485/111-42
69 pages
Go to English
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
DE
Betriebsanleitung
Additional languages r-stahl.com
DE
Erdungsüberwachungsgerät
Reihe 8485
–
F
ü
r
k
ü
n
f
t
i
g
e
V
e
r
w
e
n
d
u
n
g
a
u
f
b
e
w
a
h
r
e
n
!
–

Table of Contents

Questions and Answers

  • J
    Jacqueline FrazierAug 10, 2025
    What to do if the red indicator lamp lights up, but the green one goes out on Stahl 8485/111-42 Measuring Instruments?
    • R
      Ronald RodriguezAug 10, 2025
      If the red indicator lamp lights up and the green lamp goes out despite contact, it could be due to several reasons: * The measured value might be outside the set limiting values. In this case, connect the grounding cable with the object, read out the measured value using the configuration kit, and adjust the limiting values. * The object adjustment could be defective. Adjust the DIP switch according to the type of object being grounded. * The grounding monitoring device may have been connected after the filling arm. Disconnect the filling arm, connect the grounding monitoring device, and then reconnect the filling arm.
  • J
    Jessica RossAug 23, 2025
    Why did the red indicator lamp go out on my Stahl 8485/111-42 Measuring Instruments?
    • V
      victoria85Aug 23, 2025
      The red indicator lamp might go out due to: * Auxiliary power failure: Monitor the wiring of the auxiliary power supply. If the fuse is defective, have the device repaired. * Clamp deactivation: Activate the clamp via the software.

Stahl 8485/111-42 Specifications

General IconGeneral
CategoryMeasuring Instruments
TypePressure Gauge
Model8485/111-42
Case MaterialStainless steel
Dial Size100 mm