Technical Procedure
Page 1
620-8590 Rev. A
Latest Rev.
Required Tools:
• 2.5mm Allen Key
• 3mm Allen Key
• 4mm Allen Key
• 5mm Allen Key
• 6mm Allen Key
• 10mm Wrench
• 10mm Socket
• Ratchet
• Needle Nose Pliers
1. Remove the three (3) socket head cap screws se-
curing the brake covers to the unit using a 4mm
allen key
2. Loosen the screw securing the brake cable to
the brake, then use a 10mm wrench to remove
the M6 nut securing the brake cable to the cable
bracket.
3. Pull the entire cable from the back of the brake
cable bracket.
HIITMill (X) Push/Pull Brake Cable Install
Applies to: HIITMill and HIITMill X
To Next Page
