What to do if my Stairville SF-1500 doesn't eject any fog?
If your Stairville Fog Machine isn't ejecting fog, there are a few things to check: * Ensure that the fluid level in the fog container is adequate. * Verify the connection to the remote control. * Turn the device off, then inspect the hose leading into the fluid container to ensure there are no blockages.
Why Stairville SF-1500 Fog Machine not responding to DMX controller?
If your Stairville Fog Machine isn't responding to the DMX controller, verify the DMX ports and cables are properly connected. Also, check the DMX address settings and polarity. Try using another DMX controller to rule out issues with the controller itself. Finally, ensure that the DMX cables are not running near high voltage cables, as this may cause interference.
Overview of symbols and signal words used in the manual.
Lists warning signs and their corresponding types of danger.
Specifies the intended purpose and authorized usage of the device.
Safety precautions regarding children and choking hazards from packaging materials.
Warning about high voltages within the device and the prohibition of removing covers.
Warning against modifying the mains cable or plug to prevent electric shock or fire.
Warning about severe burns and property damage from flammable liquids.
Caution regarding hot fog nozzle and potential escape of hot fluid drops.
Warning about slippery floors due to fog condensation and how to manage it.
Advises on handling fog fluid, potential harm if swallowed, and eye contact.
Caution regarding respiratory issues from incorrect fog fluids or unventilated areas.
Warning to avoid covering ventilation slots or placing the device near heat sources or flames.
Guidance on indoor use, avoiding liquids, and proper power connection and unplugging.
Advice on using dedicated DMX cables and avoiding connection to audio devices.
Instructions for connecting the device in a DMX daisy chain with termination resistor.
Diagram and identification of the front panel components of the fog machine.
Diagram and identification of the rear panel connectors and controls.
Diagram and identification of the remote control unit's buttons and display.
Instructions for filling the fog machine with approved fog fluid, including capacity.
Steps for powering on the device, warming up, and safely turning it off.
How to trigger maximum fog output by pressing the MANUAL button.
How to activate continuous operation and adjust fog output using FUNCTION and VOLUME buttons.
Instructions for setting fog burst duration and interval times using the TIMER function.
Procedure for setting the DMX address of the device using the controller.
Details on how DMX channels control operating mode and output volume.
Guidance on environmentally friendly disposal and recycling of packaging materials.
Information on disposing of the device according to EU directive and local regulations.
General| Power | 1500 W |
|---|---|
| Fluid Tank Capacity | 2.5 L |
| Dimensions | 540 x 280 x 340 mm |
| Weight | 10.7 kg |
| Tank capacity | 2.5 L |
| Remote control | Yes |
| DMX | Yes |
| Voltage | 230 V / 50 Hz |
| Control | DMX |
| Warm-up time | 8 min |
To Next Page
