20. When moving the saw, ALWAYS have the head lowered to the
horizontal position.
缺电路部分
IMPORTANT:
Coolant pump motor voltage must always be the same as machine motor
voltage.
ASSEMBLY
A 3/4 or 1 HP motor split phase or capacitor start is recommended for best
economical performance. Counter clockwise is required. Note that
rotation can be reversed by following directions given on terminal or
nameplate.
1. Assemble the motor Mounting plate to the head using the long bolt.
Note that the flat side of the plate faces up.
2. Assemble the guard plate to the head using the screw and lock washer
and the carriage bolt. Washer and wing nut are used to secure the
motor mounting plate to the guard plate through the slotted hole in the
guard plate. These components also serve to position and lock the
motor in place or proper speed/belt adjustment.
3. Place the spacer over the long bolt and secure it with the nut.
4. Secure the motor to the motor mounting plate with the four volts and
nuts. Note that the motor shaft is placed through the large opening in
the guard plate and must be parallel with the drive shaft.
5. Assemble the motor pulley, the smaller of the two provided to the
motor shaft. Note the larger diameter must be closest to the motor. Do
not tighten the set screw.
6. Assemble the driven pulley, the larger off the two provided to the
protruding drive shaft. Note the smaller diameter must be closest to the
bearing. Do not tighten the set screw.
7. Place the belt into one of the pulley groove and the other end into the
respective grooves of the second pulley.
8. Line up the belt and both pulleys such that the belt is running parallel in
the pulley grooves.
To Next Page
Loading...