©2007 SP_SX440-AS440_07.07_01_GB
AVR CONVERSION INSTRUCTIONS
Fitting AS440 AVR in place of SX440 AVR.
• Read all instructions carefully before starting this conversion.
• Check that all the parts listed below are included with this conversion kit.
• Depending upon the type of machine being converted, not all the parts listed will be
required.
• No specialised tools are necessary.
Contents:
Item. Description. Part No. Qty. check
1 Conversion instructions (this sheet) SP_SX440_AS440_07.07_01_GB 1
2 AS440 AVR E000-24400 1
3 AS440 AVR specification sheet TD_AS440 AVR_11.06_03_GB 1
4 Terminal block (6-way) 450-15489 1
5 Fixing Screw 005-04068 1
6 Grommet 003-25161 1
7 AVR adjustment label E00-14064 1
8 AVR adjusting tool E00-10032 1
9 Cable-tie 052-45003 5
SAFETY
WARNING
Service and fault-finding procedures present
hazards which can result in injury or death.
Only personnel qualified to perform electrical
and mechanical service who are familiar with
the equipment should carry out these
procedures.
WARNING
Ensure engine starting circuits are
disabledand the generator is electrically
isolated before commencing service or
maintenance procedures.
Isolate any anti-condensation heater supply.
•
It is essential that all instruments are regularly
checked for safety, and any connection leads,
probes or clips checked to ensure that they are
suitable for the voltage levels being tested.
•
Never attempt to test a generator when the
engine is running (LIVE) unless there is another
competent person present who can switch off
the power supply and shut down the generator
in an emergency.
•
Never expose electrical components with the
power on (LIVE) without creating a safe working
area around you. Make sure you have made all
other persons, in the immediate area, fully
aware of what you are doing.
•
These instructions have been written for use
with the AVR specification as originally supplied
with the generator.
To Next Page
Need help?
General
