EasyManua.ls Logo

Stamina 35-1691 - Assembly Steps: Unfolding; Step 1: Initial Placement; Step 2: Securing and Unfolding

Stamina 35-1691
19 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ASSEMBLY INSTRUCTIONS
7
Wire Ring
2.
1.
STEP 1
Lay the trampoline on the oor. The trampoline will appear as shown in illustration 1.
To unfold the Stamina® Oval Fitness Trampoline to the at position, hold the SEMICIRCLE RAILS(2)
and push the rails down at the same time. The SEMICIRCLE RAILS(2) and RAILS(1) should snap together
and be locked by the SECURE PINS(8) when you reach the at position. Refer to illustration 2.
Hazard label on trampoline surface reads as follows:
!
WARNING!
PREVENT serious INJURY or DEATH.
Rails can SPRING back and STRIKE someone.
ALWAYS fold and unfold carefully with TWO or
more STRONG people.
Do NOT remove this tag.
ALWAYS USE TWO OR MORE STRONG PEOPLE TO UNFOLD OR FOLD THE
Stamina® Oval Fitness Trampoline. FAILURE TO USE TWO OR MORE STRONG
PEOPLE MAY ALLOW THE RAILS TO SPRING BACK INTO THE FOLDED
POSITION AND STRIKE SOMEONE WHICH CAN CAUSE SERIOUS BODILY
INJURY OR DEATH.
Keep ngers away from the ends of the rails in the hinge area when unfolding the
Stamina® Oval Fitness Trampoline. Serious injury can occur if ngers are caught
between the ends of the RAILS.
STOP!
STEP 2
NOTE: Make sure the SECURE PINS(8) are inserted into the ends of RAILS(1, 2) and properly secured
by the Wire Ring. Both ends of the SECURE PINS(8) should have approximately 1/8 inch between
the RAILS(1, 2) and the Wire Ring. Refer to illustration 2.
!
WARNING

Related product manuals