Read instruction carefully prior to assembly.
Thank you for purchasing this quality product. Check carefully for small parts which may come loose during shipment. Remove all components from
pack and place top down on soft surface such as carpet or cloth to prevent scratching the finish. Identify and count all parts as specified below.
It is recommended to use two or more person during the assembly process.
ASSEMBLY INSTRUCTION
GROUP NO.: 14140 CABANAS DR
ITEM NO.: 14141 - DINING TABLE W/18' LEAF
HARDWARE LIST: PART LIST:
No.
Description Sketch
Qty'
1
Long Bolt
Size
ɸ
5
16
'' x 50mm
4 pcs
3
4
Lock Washer
ɸ
5
16
'' x 13mm
12 pcs
5
Big Flat
Washer
ɸ
5
16
'' x 19mm
8
pcs
6
Allen Key
4 mm7 1
pc
No.
Description Sketch
Qty'
Table 's Screw
12
pcs4mm x 30mm
Small Flat
Washer
ɸ
5
16
'' x 12mm
4
pcs
A
Table Top
1 pc
C
Table Leg
2 pcs
Made in Vietnam
Cleaning instructions: Clean using soft cloth
Step 1 Step 2
Step 2: Attach the Mounting Plate (E) to the assembly base
in Step 1 by using Short Bolt (2), Lock Washer (3), Big Flat
Washer (4) and fully tighten with Allen Key (7). Do not over
tighten.
Step 3: Place the Table Top (A) upside down on a piece of
cloth or carpet to prevent finish from scratching. Aligning
the Wood Dowel on the Mounting Plate (E) to the pre-drilled
hole on the table slide of Table Top (A). Attach the assembly
Base in step 2 to the Table Slide of the Table Top (A) by
using Table's Screw (6) and fully tighten with Phillips-head
screw driver (not provided).
Step 3
F
Wood Plug Decor
2 pcs
Step 4: Turn the Table to upright position and fully tighten all
Bolts and Screws. Attach Wood Plug Decor (F) to the Table Leg
(C) by aligning the Wood Dowel of the Wood Plug Decor (F) to
the pre-drilled hole out side of Table Leg (C).
Unlock the Latch and pull the Table Top (A) from both ends.
Insert Table Leaf (B) to the middle of Table Top (A), close the
Table Top (A) by pushing from both ends. Lock the latch to
prevent from sliding. Assembly product is now completed.
Step 4
STANDARD
furniture
2
Short Bolt
ɸ
5
16
'' x 40mm
8 pcs
D
Stretcher Support
1 pc
Wood
Dowel
7
1
3
5
Step 1: Align the Wood Dowel of the Stretcher Support (D)
to the middle hole on the Table Leg (C). Attach 2 Table Legs
(C) to the Stretcher Support (D) by using Small Flat Washer
(5), Lock Washer (3) and Long Bolt (1) with Allen Key (7).
Do not fully tighten.
C
D
C
C
C
D
E
Mounting Plate
1 pc
7
2
3
4
C
D
E
C
C
E
Wood
Dowel
Hole
LOCK
UNLOCK
6
E
F
B
Table Leaf
1 pc
A
B
E
To Next Page
Need help?
General
