How to fix a Stanford Research Systems DS360 that does not turn on?
If your Stanford Research Systems Inverter doesn't power on, check the following: * Ensure the power entry module on the rear panel is set to the correct line voltage. * Verify the correct fuse is installed. * Confirm the line cord is fully inserted into the power entry module.
How to reset a Stanford Research Systems Inverter?
To perform a full reset on your Stanford Research Systems Inverter, hold down the [CLR] key while turning the power on.
Critical safety warning regarding dangerous voltages and caution when using the instrument.
Warning about potential damage from incorrect line voltage or fuse.
Procedure for selecting the correct AC input voltage.
Information on the correct fuse types for different voltage settings.
Explains how to use the keypad and spin knob for parameter adjustment.
Explains the function and operation of the front panel keypad.
Describes the power-on sequence and self-tests.
How to set function type, frequency, amplitude, and offset.
Details on selecting output type and source impedance.
Setting sweeps, bursts, and bandwidth-limited noise.
Configuring default settings, GPIB, and RS-232 interfaces.
Discusses common problems, error messages, and solutions.
Rules for formatting commands, mnemonics, and parameters.
Commands for controlling analog output functions.
Commands for controlling digital output functions.
Commands for sweeps, bursts, and noise modifications.
How to configure function type, frequency, amplitude, and bits.
Measures the frequency accuracy of the DS360.
Measures the amplitude accuracy for sine, noise, squarewave, and balanced outputs.
Tests harmonic distortion for sine/square waves and noise levels.
Measures the offset accuracy of the DS360.
Confirms the output source resistors of the DS360.
General| Brand | Stanford Research Systems |
|---|---|
| Model | DS360 |
| Category | Inverter |
| Language | English |
To Next Page