1. PURPOSE
1.1 Discussion
This manual provides installation instructions for the Stanley 7400-Series ICU door system. The
7400-Series ICU door is a fully manual door system that features either two swinging panels or
one swing door (single). The most common application for the door system is a hospital
intensive care unit.
1.2 Applicability
This manual is applicable to the Stanley 7400-Series ICU door system.
1.3 Features and Functions
The 7400-Series ICU door system includes the following features:
• For active panels, a swing-door closer assembly embedded in the panel and header.
(Inactive panels use a flush bolt and do not have a closer.) The closer assembly includes
two setscrews. One screw adjusts the door closing speed as it closes from 105° to 15°. The
other screw adjusts the latch closing speed throughout the last 15°.
• A 105° hold-open feature. When the swing door is opened to greater than 105° the door
closer holds it open.
• Flush bolt on the inactive panel
• Lever handle and push handle on the active panels
• Smoke and draft option
• Continuous hinges
2. PREREQUISITES
2.1 Protective barrier (caution/warning tape) has been set up to prevent unauthorized access to work
area.
2.2 Attachment 1 has been reviewed for the following:
• Definitions of the terms used in this procedure
• A listing of the additional documents required during this procedure
• A listing of the tools, equipment, materials, and consumables used in this procedure.
204068
Rev. B, 2/26/11
12011. THE STANLEY WORKS, ALL RIGHTS RESERVED. 2 of 1 5
To Next Page
Loading...