Stanley 7400-Series - Page 5

3.3.1 Refer to Figure 1, and, using three % -20 X l3// screws and spring lockwashers,
ATTACH header bracket to rivnuts in jamb.
3.3.2 POSITION end of header extrusion over the header bracket.
3.3.3 Using four 'A -20 X V/ CS screws, ATTACH header to header bracket.
3.3.4 REPEAT Section 3.3 for opposite end of header.
©2011, THE STANLEY
WORKS. ALL RIGHTS RESERVED.
204068
Rev. B, 2/26/11
4 of 15