To Next PageTo Next Page
Need help?Do you have a question about the Stanley BXGT10147E and is the answer not in the manual?
Consider hose reach based on reel capacity (10-30m).
Ensure proximity to water source for leader hose (1-2m).
Verify structure can support reel weight (up to 14.5kg/32lbs with water).
Protect reel and hose from sunlight damage to extend product life.
Use mounting bracket as template, mark holes, ensure vertical alignment with a level.
Drill holes using appropriate drill bit for material (masonry or timber).
Insert anchor plugs into drilled holes for wall mounting.
Secure mounting bracket using provided screws and washers (B.1 or B.2).
Hang hose reel (C) on wall bracket (D), secure with mount tube (E).
Connect the leader hose to the water source.
Pull hose to desired length; it locks automatically or with a pause.
Pull out 300mm of hose to initiate retraction into the reel.
Hold hose during retraction; do not release to prevent injury or damage.
Extend hose fully, untwist, then allow to retract.
Modify stop-ball position to control exposed hose length when rewound.
Turn off water source and release pressure when not in use.
Store indoors during winter months to prevent freezing and damage.
Clean housing and hose using only mild soap and water.
General
