Need help?Do you have a question about the Stanley 100 and is the answer not in the manual?
Clips are loaded into the magazine by pulling the follower back and inserting clips with the single ear forward.
Recommended air pressure is 80-110 PSI. Attach hose with a quick-disconnect fitting, using a wrench on the valve assembly.
Apply a drop or two of oil in the air inlet and on the blade daily.
Grease the front of the driver blade when the tool is disassembled.
Ensure bolts are tightened as necessary for proper tool function.
Use wire to clean tape from the blade slot.
Lists wire sizes and tool/clip models for furniture applications.
Lists wire sizes and tool/clip models for box spring applications.
Lists wire sizes and tool/clip models for automotive spring applications.
Jamming due to backward loaded clips with double ears forward.
Jamming caused by placing wires at the bottom of the anvil hook.
Tool not actuating; pilot valve may be stuck.
Driver blade not returning freely; check for binding or replace O-ring.
To Next Page
General
