0412 - BPL062 - 13 KW Hydraulik GmbH – 96515 Sonneberg – Germany – www.kw-hydraulik.de
English
PERFORM OTHER CRIMPINGS IN THE SAME WAY.
To remove the dies, open the head and then remove the dies.
Put the connector with the cable inserted be-tween the two dies.
CHECK THAT THE LOCK IS CLOSED CORRECTLY BEFORE CRIMPING
Press the crimping trigger until an audible "click" is heard. The LED light up (see INDICA-
TIONS LED).
CAUTION: THE DIES TIGHTEN VERY TIGHTLY. DO NOT SLIDE YOUR FI
THE DIES PROFILE.
Press the release trigger to retract the piston.
Press the b
utton ON/OFF tool. The LED light
up (see LED INDICATIONS).
Slide the battery into the handle of
the press until you hear a click
USING THE TOOL
USING THE TOOLUSING THE TOOL
USING THE TOOL
Select the dies set. Insert the dies into the
crimping head (ball headed dowel).
the crimping connector.
To Next Page
Loading...