9
(Original Instructions) ENGLISH
You can check the location of your nearest authorised
repair agent by contacting your local STANLEY office at
the address indicated in this manual. Alternatively, a list
of authorised STANLEY repair agents and full details of
our after-sales service and contacts are available on the
Internet at: www.2helpU.com.
Batteries
STANLEY batteries can be recharged many
times. At the end of their useful life, discard
batteries with due care for our environment:
• Run the battery down completely, then remove it from
the tool.
• NiCd, NiMH and Li-Ion batteries are recyclable. Take
them to any authorized repair agent or a local recycling
station.
NOTES
STANLEY’s policy is one of continuous improvement to
our products and as such, we reserve the right to change
product specifications without prior notice. Standard
equipment and accessories may vary by country. Product
specifications may differ by country. Complete product
range may not be available in all countries. Contact your
local STANLEY dealers for range availability
SERVICE INFORMATION
STANLEY offers a full network of company-owned and
authorized service locations. All STANLEY Service Centers
are staffed with trained personnel to provide customers
with efficient and reliable power tool service. For more
information about our authorized service centers and
if you need technical advice, repair, or genuine factory
replacement parts, contact the STANLEY location nearest
you.
TECHNICAL DATA
IMPACT DRIVER SBI201
Voltage V
DC
18
No-load speed min
-1
0-2700
Beats per minute bpm 0-3100
Max torque (PTI Method) Nm 180
Bit holder capacity mm 6.35(Hex)
Weight kg 1.3
Charger SC201 SC202
Input voltage V
AC
230 230
Output voltage V
DC
18 18
Current mA 1000 2000
Approx. charge time Mins 80-240 40-120
Battery SCB20C SCB20S SCB20D ZSCB20M
Voltage
V
AC
18 18 18 18
Capacity
Ah 1.3 1.5 2.0 4.0
Type
Li-Ion Li-Ion Li-Ion Li-Ion
Level of sound pressure according to EN 62841:
Sound pressure (L
pA
) dB(A) 97
Sound pressure uncertainty (K
pA
) dB(A) 3
Sound power (L
WA
) dB(A) 108
Sound power uncertainty (K
WA
) dB(A) 3
Vibration emission values (Triax vector sum) according
to EN 62841:
Fastening with impact (a
h
,
IS
) m/s
2
12.2
Uncertainty (K) m/s
2
1.5
VIBRATION
The declared vibration emission values stated in the
technical data and the declaration of conformity have been
measured in accordance with a standard test method
provided by EN 62841 and may be used for comparing one
tool with another. The declared vibration emission value
may also be used in a preliminary assessment of exposure.
WARNING! The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which
the tool is used. The vibration level may increase
above the level stated.
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons
regularly using power tools in employment, an estimation of
vibration exposure should consider, the actual conditions of
use and the way the tool is used, including taking account
of all parts of the operating cycle such as the times when
the tool is switched off and when it is running idle in addition
to the trigger time.
To Next Page
Loading...