To Next PageTo Next PageWhy Stanley SG 2400 Basic Inverter generator has too little or no voltage?
The Stanley Inverter generator may have too little or no voltage due to a few reasons: * **Overload cut-off:** The overload cut-off may have been triggered. Actuate the circuit-breaker and reduce the number of connected devices. * **Dirty air filter:** The air filter might be dirty. Clean or replace the filter.
What to do if my Stanley SG 2400 Basic engine does not start?
If your Stanley Inverter's engine won't start, there are several potential causes: * **Oil shortage:** Check the oil level and top up the engine oil if needed. * **Spark plug fouled:** Clean or replace the spark plug, ensuring the electrode spacing is 0.6 mm. * **No fuel:** Refuel the inverter and check the petrol cock. * **Low battery voltage:** Charge the battery.
Step-by-step guide for starting the generator engine.
How to connect electrical devices to the generator's outlets.
Procedure for changing engine oil and checking the oil level.
General
