Need help?Do you have a question about the Stanley SS30 and is the answer not in the manual?
Read all safety warnings, instructions, illustrations and specifications provided with this power tool.
Keep work area clean and well lit. Avoid explosive atmospheres. Keep children and bystanders away.
Ensure power tool plugs match outlets. Avoid contact with earthed/grounded surfaces. Use RCD in damp locations.
Stay alert. Use PPE. Prevent unintentional starting. Do not overreach. Dress properly. Use dust extraction.
Do not force the tool. Use correct tool for application. Disconnect power before adjustments. Maintain tools.
Hold by insulated surfaces. Avoid dust inhalation. Remove dust. Take care with lead-based paint or toxic dust.
Use a residual current device (RCD) with 30mA or less. Check main voltage. Replace damaged cord by authorized personnel.
Tool not for persons with reduced capabilities. Children should be supervised. Do not let children play with appliance.
Risks include impairment of hearing, injury from flying particles, burns, prolonged use, and hazardous dust.
Tool is double insulated. No earth wire required. Check voltage. Damaged cord needs authorized repair.
Use approved 3-core cable. Minimum 1.5mm² conductor. Max length 30m. Unwind cable reels completely.
Instructions on how to attach sanding paper to the sanding pad.
How to adjust the sanding speed using the electronic speed control dial.
Steps to fit and lock the dust bag collar to the dust outlet.
Instructions on how to remove, empty, and reattach the dust bag.
Always use proper hand position as shown for safety.
How to operate the on/off switch and set the speed control dial.
Tips for effective sanding, including grit selection and pressure.
Advice on pressure, checking sandpaper, and grit selection for different surfaces.
Instructions for cleaning the tool using dry air and approved methods.
The power tool requires no additional lubrication.
To Next Page
General
