© 2017, Obelis S.A Registered Address:
Bd. Général Wahis, 53 1030 Brussels, Belgium
NEVER LEAVE HEATER UNATTENDED WHILE
CONNECTED TO A POWER SOURCE
9
RISK OF ELECTRIC SHOCK!
DISCONNECT FROM POWER
BEFORE MAINTENANCE.
WARNING
Plug Replacement
NOTE: This section only applies to heaters sold or used in Great Britain.
This appliance is supplied with a BS1363
3 pin plug tted with a fuse. Should the
fuse require replacement, it must be
replaced with a fuse with the proper amp
rating. (see Technical Specications page
5) and approved to BS1362.
In the event the mains plug has to be
removed/ replaced for any reason, please
note:
IMPORTANT: The wires in the mains
lead are colored in accordance with the
following code:
Blue – Neutral Brown – Live
Green/Yellow – Earth
As the colors of the wires in the mains
lead of this appliance may not correspond
with the colored markings identifying the
terminals in your plug, proceed as follows:
The blue wire must be connected to the
terminal marked with an N or colored
black. The brown wire must be connected
to the terminal marked with an L or
colored red. The green/ yellow wire must
be connected to the earthing terminal
which is marked with an E or with the
earth symbol.
NOTE: If a moulded plug is tted and
has to be removed take great care in
disposing of the plug and severed cable,
it must be destroyed to prevent engaging
into a socket.
Never
connect
live or neutral wires
to the earth termi-
nal of the plug.
To Next Page
Loading...
