Need help?Do you have a question about the Stanley STMT81251-1 and is the answer not in the manual?
Understand and follow all instructions before operating the device.
Do not exceed the rated capacity of the hydraulic trolley jack.
Support the jack on a solid, level, and horizontal surface.
Ensure vehicle is safe before lifting: engine off, brake applied.
Position jack to avoid placing body parts under the vehicle.
Turn sleeve clockwise, pump lever, and secure load with axle stand.
Lift vehicle to remove stands, then turn handle counter-clockwise to lower.
Keep jack clean, lubricate moving parts, and use original spare parts.
Check oil level, fill with ISO VG22 hydraulic oil, do not overfill.
Keep jack clean, lubricated, and protected from dirt and elements.
Check release valve, hydraulic fluid level, air locks, capacity, and valves.
Check pump operation, seals, and cylinder packing.
Inspect and replace worn or damaged seals.
Ensure release valve is closed; check cylinder, springs, and link sections.
Identifies parts like wheel assembly, saddle, carrying handle, and power unit.
To Next Page
General