10
OPERATIONS
13. Relay
In the Relay-operation, the device automatically switches to the other player after every track. In this way, you have the
possibility to enlarge the music program by using several CDs.
Possibility 1:
Connect the Control-sockets of the two CD-players with one another. The Relay-button must remain unpressed (LED
off).
Press the Single-button (The display shows “SINGLE”) on both CD-player. Start playback of CD1. As soon as the
current track of CD1 is finished, the player automatically starts CD2. The first CD-player goes into Pause-mode. You
can enter a new CD or memorize a Cue-point at the respective player in the Pause-Mode.
CAUTION: The Relay-operation does not work properly if the two CD-players are connected to different power
amplifiers.
Possibility 2:
Press the Relay-button (LED on).
In the Single-mode, the device automatically starts with the playback of the other CD-player of the other CD-player at
the end of the track.
To Next Page
Loading...
