STAR Water Systems 025191

Questions and Answers

N
Nicole MoralesAug 8, 2025
How to troubleshoot a STAR Water Systems 025191 Swimming Pool Pump motor that will not start?
- R
  Ronald MedinaAug 8, 2025
  If your STAR Water Systems Swimming Pool Pump motor won't start, begin by checking all wiring connections, circuit breakers, and fuses. Ensure connections are secure and that there are no open switches or relays. Reset any tripped breakers or replace blown fuses. Also, check the rotation of the motor shaft and ensure the timer is working properly. If necessary, bypass the timer to see if that resolves the issue.
M
Megan HardingAug 13, 2025
What to do if my STAR Water Systems 025191 Swimming Pool Pump won't prime?
- G
  Garrett ArnoldAug 13, 2025
  If your STAR Water Systems Swimming Pool Pump won't prime, ensure the pump and strainer housing are filled with water and that the cover O-Ring is clean, properly seated in the cover O-Ring groove, and lubricated. Make sure the strainer cover is locked firmly in position. Also, tighten any loose pipe or union connections on the suction side. Remove the strainer housing cover or skimmer cover, clean the basket, and refill the strainer housing with water, then tighten the cover. If the suction side is clogged, contact a qualified repair professional.
D
diana47Aug 22, 2025
How do I fix a noisy STAR Water Systems Swimming Pool Pump?
- P
  Paul CampbellAug 23, 2025
  A noisy STAR Water Systems Swimming Pool Pump can be caused by several factors. Check for air leaks in the suction piping, cavitations due to a restricted or undersized suction line, a leak at any joint, low water level in the pool, or unrestricted discharge return lines. Correct the suction condition or throttle return lines, if practical. Vibration due to improper mounting can also cause noise, so replace the mounting if necessary. Clean the pump housing to remove any foreign matter. If the motor bearings are noisy due to normal wear, rust, overheating, or chemical concentration causing seal damage, all seal leaks should be replaced at once.
G
Gail SullivanAug 28, 2025
What to do if STAR Water Systems Swimming Pool Pump motor hums but does not start?
- E
  Ellen JordanAug 28, 2025
  If your STAR Water Systems Swimming Pool Pump motor hums but doesn't start, the impeller may be jammed with debris. Have a qualified repair professional open the pump and remove the debris.
C
Cheryl AbbottSep 1, 2025
Why does my STAR Water Systems Swimming Pool Pump motor shut off?
- Q
  qcardenasSep 1, 2025
  Your STAR Water Systems Swimming Pool Pump motor might be shutting off due to low voltage at the motor or a power drop, often caused by undersized wiring or the use of an extension cord. Contact a qualified professional to check that the wiring gauge is heavy enough.
M
moorekimberlyNov 17, 2025
Why is the water flow low in my STAR Water Systems 025191?
- L
  Laurie OnealNov 17, 2025
  Low water flow in your STAR Water Systems Swimming Pool Pump can be due to several reasons. A clogged or restricted strainer or suction line might be the cause, in which case you should contact a qualified repair professional. Other causes include undersized pool piping (correct the piping size), a plugged or restricted discharge line of filter, or a valve that is partially closed (high gauge reading). For sand filters, backwash as per manufacturer’s instructions; for D.E. filters, backwash as per manufacturer’s instructions; and for cartridge filters, clean or replace the cartridge. Also, check for air leaks in the suction (bubbles issuing from return fittings) and re-tighten using Teflon tape. Finally, a plugged, restricted, or damaged impeller may be the cause, so replace it, including ...