Star mPOP - Peripheral and Cable Management; Connecting the peripheral devices; Wiring the Cables; Securing and Adjusting the Unit

Wiring the Cables
Wire the cables as needed according to the location where the
main unit is installed. Turn OFF the main unit power before
connecting or disconnecting the cables.
Connecting the peripheral devices
Connect the specied USB device, tablet / smartphone you want
to charge, etc. to the USB connector of the product.
Securing the Main Unit
Secure the main unit in order to prevent it from tipping over.
Turn OFF the main unit power, then follow the procedure below.
Select a at, level location to install the main unit.
Place the mounting template so that the “FRONT” edge of the
mounting template is aligned with the front of the installation
position. Remove the liner from the tape on the bottom of
the mounting br acket and adhere the mounting bracket in
accordance with the mounting template. The tape has strong
adhesion. Please carry out the adhering work carefully.
Adjusting the Coin Tray
For the owners of other companies’ trademarks mentioned in this document, see Trademarks in
our website (https://www.star-m.jp/eng/trademarks.html).
Copyright 2022 Star Micronics Co., Ltd.
Installing the Barcode Reader
Connect the barcode reader cable to the main unit.
Assemble the barcode reader stand.
Use the double-sided tape or screws as necessary to fasten the
stand in place.
USB-A
USB-C
Designated barcode reader, LCD Display
Other peripheral devices
Tablet or other peripheral device
Plug for the mPOP
:
Plug for the mPOP
:
Route the USB cable so that it passes under the USB cable hooks.
To ensure the main unit is not tilted when installed, beware
that cables do not protrude from the hooks while the cables
were routed.
Press the mounting bracket rmly so that the tape is adhered to
the surface securely.Remove the mounting template.
Check the position of the slot for mounting bracket on the
bottom of the main unit, and position the main unit so that the
slot is in front of the mounting bracket hook .
Slide the main unit so that the mounting bracket hook enters the
slot to secure the main unit in place.
If you want to secure with screws, please refer to the online
manual.
Press the hook part on the bottom of the divider with a narrow
pointed tool to disengage the lock
❶
, then lift up the divider
❷
.
Press the coin tray from the inside with your ngers to expand it
❸
,
and then remove the divider
❹
.
Install the divider in the desired position.
Unlock the hook A on the divider
❶
and lift it up
❷
.
Install the divider in the desired position.
(North, Central & South America Only)
Place the barcode reader into the barcode reader stand.
Route the power cable so that it passes under or between the
power cable hooks.
Use your chosen application or other means to open the cash
drawer, and then remove the coin tray.
A
1
2
2
1
3
4
1
2
4
3
Models with Barcode Reader or as an Option
1 2
Communication
Power Cable
Vertical Bill Type
Flat Bill Type
USB Cable
Recharge
Recharge
1
2