Starfire VisionFive 2 - Figure 4-9 Boot Mode Settings

To Previous Page













Main Page

Table of Contents5
List of Tables6
List of Figures7
Features and Specifications8
Features8
Hardware8
Interfaces8
Software9
Specifications9
Hardware Overview12
Board Appearance12
Figure 2-1 Board Appearance (Top View)12
Figure 2-2 Board Appearance (Bottom View)12
Pinout Diagram14
Figure 2-4 Pinout Diagram14
Getting Started15
Required Hardware15
Figure 3-1 Npths on Visionfive 215
Figure 3-2 Single Head Hexagonal Copper Columns15
Connecting a Fan to Visionfive 216
Figure 3-3 Double Way Hexagon Copper Studs16
Figure 3-4 SSD Mounting Location16
Flashing os to a Micro-SD Card17
Flashing with Linux or Windows17
Figure 3-5 Connecting a Fan to Visionfive 217
Logging into Debian18
Figure 3-6 Install Balenaetcher18
Using Desktop over HDMI19
Using SSH over Ethernet19
Figure 3-7 Debian Interface19
Figure 3-8 Example Output21
Using a USB to Serial Converter22
Figure 3-9 Example Output22
Figure 3-10 Connecting Jumper Wire22
Figure 3-11 Example23
Figure 3-12 Example Configuration24
Figure 3-13 Example Output24
Figure 3-14 Connecting Jumper Wires25
Figure 3-15 Example Output25
Figure 3-16 Example Output26
Figure 3-17 Example Output26
Appendix27
Using SSH over Ethernet as Root Account27
Extend Partition on SD Card or Emmc27
Updating SPL and U-Boot29
Updating SPL and U-Boot of Flash29
Updating SPL and U-Boot of SD Card and Emmc30
Recovering the Bootloader31
Figure 4-1 Connecting to the Debug Pins of Visionfive 2 40-Pin GPIO Header31
Figure 4-2 Boot Mode Setting (UART)32
Figure 4-3 Example Output32
Figure 4-5 Example Output33
Figure 4-7 Example Output34
Github Repository35
Boot Mode Settings36
Figure 4-9 Boot Mode Settings37

Starfire VisionFive 2 - Figure 4-9 Boot Mode Settings

Table of Contents