STARFRIT 024002 - Coffee Maker Operation; Before First Use; How to Make Coffee; Cleaning and Maintenance

5
BEFORE FIRST USE
READ THE INSTRUCTIONS BEFORE USE
NOTE: Remove all parts & accessories and dispose of packaging.
Check that all accessories are complete and the unit is not damaged. Add water into water tank
to the max level and brew water for several times without coee powder, then discard the water.
Clean all detachable parts thoroughly with warm water.
HOW TO MAKE COFFEE
A. Open the top lid and fill the water tank with drinking water. The water level should not exceed
the “Max” level as indicated in the water tank. (Fig. 1)
B. Place the permanent filter and funnel in the funnel support, make sure it is
assembled correctly, otherwise the cover will not close properly. (Fig. 2)
C. Add coee grounds into permanent filter. Usually 1 level tablespoon of
medium coee grounds requires 1 cup of water for each cup of brewed
coee. However, you can adjust according to personal taste.
D. Insert a conventional coee mug or the travel mug under the water tank
horizontally.
E. Plug the power cord into the outlet.
F. Press the switch, the indicator will light up in red and the appliance will
start working.
G. After brewing is complete, the indicator light will extinguish indicating
your coee maker is turned o.
H. Remove mug to serve or drink when brewing is complete (about one minute after the coee
stops dripping out.) NOTE: The volume of coee you get will be less than the water you have
added, as some water is absorbed by the coee grounds.
I. Always turn the coee maker o and disconnect the power supply when not in use. NOTE:
Pay close attention when serving or drinking coee. Once the brewing is over, the coee’s
temperature will be very high.
CLEANING AND MAINTENANCE
CAUTION: Be sure to unplug this appliance before cleaning. To protect against electrical shock, do
not immerse cord, plug or unit in water or any other liquid. After each use, always make sure plug is
first removed from wall outlet.
1. Clean all detachable parts after each use in hot soapy water.
2. Wipe the exterior surface of unit with a soft, damp cloth to remove stains.
3. Water droplets may buildup in the above area of the funnel and drip onto the product base
during brewing. To control the dripping, wipe o the area with a clean, dry cloth after each
use.
4. Use a damp cloth to gently wipe the mug rest and travel mug. Never use an abrasive cleaner.
5. Assemble all parts and put aside for next use.
Permanent filter
Filter holder
Water tank
Travel mug