OPERATION
6
WARNING: ALWAYS test the function of the engine control module before operating the trowel. DO
NOT operate the trowel if the engine control module is not functioning properly.
Choose correct blade type and attach blades to trowel arms. Do not mix oat or nish blades with
combination blades.
CAUTION: Do not attempt to adjust handle height on the trowel while it is running.
WARNING: Allow the mufer to cool before cleaning or servicing the machine. A hot mufer could
ignite the fuel and start a re.
WARNING: Personnel other than the trowel operator should not be allowed in the work area, as severe
injury can occur from contact with operating trowel blades.
MAINTENANCE The chart below lists basic machine and engine maintenance.
Perform initially after rst 20 hours of operation.
In the interests of environmental protection, place a plastic sheet and a container under the machine
to collect any liquid which drains off. Dispose of this liquid in accordance with environmental protection
legislation.
To Next Page
Loading...
General