13
Cleaning with spray bottle and wiper attachment*
Press the spray lever on the bottle to apply the detergent and spray the surface evenly; after
that, loosen the dirt using the wiping pad.
Note: Rinse pad under running water if needed!
Illustration
Switch the appliance on, the charge/operations display will illuminate.
Important: Prior to use, ensure that the squeegees are free of soiling.
Pull the appliance from the top to the bottom to vacuum up the detergent.
Note: Hard to reach areas can be vacuumed vertically or horizontally (limited areas).
Notes:
If the battery is low, the charging / power indicator starts flashing slowly and the appliance switches
off after a certain time. If this is the case, charge the battery.
The appliance can be switched off while the spray bottle is in use. This significantly increases the
operating time per battery
charge.
Interrupting the work
Switch off the appliance and put it down on the pedestal.
Emptying the reservoir during operation
Once the max. fill level (mark) of the dirt water reservoir is reached, please empty the tank.
Finish up your work / clean appliance
Shake the machine to rinse the separator while clean water stock in the reservoir tank. Clean
the suction nozzle under running water (not dishwasher safe).
Caution: The basic appliance contains electrical components. Do not clean this under running
water!
Remove the wiping cover from the spray bottle and rinse it under running water. The wiping
cover can also be washed in the washing machine at a temperature of up to 60°C(without the
use of fabric softeners).
Let the cleaned appliance dry prior to assembly.
To Next Page
Loading...
Need help?
General